x

DDM4000 & Traktor 3 Setup

Home 2023 › Forums › Digital DJ Gear › DDM4000 & Traktor 3 Setup

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 26, 2011 at 10:27 am #7887
    Pär Hessler
    Participant

    In Traktor, have you chosen DDM4000 soundcard?
    Also in your computer (Mac or PC?) have you chosen DDM4000 as soundcard.
    If PC do you have the right ASIO driver installed?
    Do you have the laterst upgrades installed in all of your Hard and soft – ware??
    And are you sure that it is Traktor 3? It should be Traktor 2??

    That is a few things to check.

    Hope it helps….

    //DJ Hessler

    September 26, 2011 at 5:18 pm #7900
    Craig McVeigh
    Member

    Cheers for the reply.

    I’m using a PC and Traktor 2! 🙂

    All software is up to date, but I’m not too sure about the ASIO – is there a link for this?

    Since posting, I’ve been messing about a wee bit and have made some (slight) progress. I had to switch the MIDI on for each individual aspect of the mixer (crossfader, fx, channels etc), and can now control Traktor with these.

    I still seem to be having problems with the soundcard though Not sure if I’m in the right place, but I’m trying to do this through:

    Audio Setup -> Audio Device

    In here I’ve got the option to use the PC, each CDJ, or Audio 4. Should I have another option in here?

    Any other audio from the PC now comes through the mixer but not whhen using Traktor!

    Bit more of a novice than I thought.

    Cheers again for any advice.

    September 27, 2011 at 5:34 am #7909
    Pär Hessler
    Participant

    I think it is a MIDI mapping issue, I could not find any mapping for DDM4000 and Traktor 2
    You might use a mapping for Traktor 1??
    Is that the case then you have to check the mapping and try to find a mapping for T2 or make your own mapping…..

    But first. Have you read and done as it stands in the Traktor 2 getting started PDF that comes with Traktor??

    http://www.native-instruments.com/fileadmin/ni_media/downloads/manuals/Traktor_2_Getting_Started_02.zip

    //DJ Hessler

    September 28, 2011 at 8:05 pm #7961
    Craig McVeigh
    Member

    Will have a look through the guide cheers.

    Is the .tsi file the same as mapping? Think I should be ok with that if I play about with it a bit.

    Just need to figure out the soundcard issue…

    September 29, 2011 at 5:02 am #7976
    Pär Hessler
    Participant

    Yes the .tsi is the mappingfile.

    Hope that you get it to work 🙂

    //DJ Hessler

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • The forum ‘Digital DJ Gear’ is closed to new topics and replies.