x

Recording a set on TP2

Home 2023 › Forums › DJing Software › Recording a set on TP2

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • June 28, 2011 at 5:33 pm #1376
    DJVendetta
    Member

    You need to go into preferences>recording and set it to internal instead of external

    June 28, 2011 at 5:52 pm #1386
    DjSpekz
    Member

    I tried doing that but the file still comes up blank. Im trying to change the format to mp3 and see if its good

    June 28, 2011 at 6:44 pm #1409
    B3AM
    Participant

    i had the same issue… I”m using an s4 and my recording setup was fixed to record out of the s4.. I had no sound but the file would show as well. I switched it to make sure it recorded inside my macbook instead and everything worked fine since then.

    June 28, 2011 at 6:50 pm #1413
    Justin
    Member

    Like what was said above, make sure that your under the “Mix Recorder,” your source is set to “Internal” rather than “External.” Also, check your “Output Routing” tab, and make sure that “Output Record” is set to whichever output you have selected as your Master Output.

    June 28, 2011 at 9:04 pm #1454
    fullenglishpint
    Member

    the gain might be turned all the way down in the recorder. Check that the VU meters are showing a reading in the mix recorder itself.

    June 29, 2011 at 6:25 am #1000585
    DJ GRE
    Member

    I was just about to say, check the gain – both on the recorder and the master, usually for gigs I keep it around -7.5 ; but when recording this makes it come up too quiet so i’ll set it to 0 for recordings, usually. make sure the recorders ‘meter’ is moving and is close to – not actually, but close to the red.

    July 4, 2011 at 9:02 pm #2865
    Chris Jennings
    Participant

    Are you getting movement from the recording meters?

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • The forum ‘DJing Software’ is closed to new topics and replies.