x

Stanton SCS.3 System and Traktor LE setup

Home 2023 › Forums › DJing Software › Stanton SCS.3 System and Traktor LE setup

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 24, 2011 at 4:27 pm #8975
    DJ GRE
    Member

    Hello pancakes! Congratulations on the new system – I own one and use it with traktor it works great! So… you wanna have Darouter started first before you start traktor, select the preset you wanna use then open traktor. From there run the setup wizard since you have LE and it should ask you if you are using an external controller, say yes and it should give you a dropdown menu to select from. Choose the stanton scs3 system. Now it’s been a while so I don’t remember exactly how LE works but go to controller manager or something similar and there should be an in and out dropdown tab – make sure you choose the darouter option for both, after this you will need to load the SCS3 LE preset located on your computer under stanton. This is from memory from over a year ago so it’s a bit sketch but it’s the basic premise. Also… what exactly were you encountering. Let me know if this helps!

    Thanks!

    October 25, 2011 at 3:02 am #9000
    Angelo Medina
    Participant

    I finally could use traktor! with only some problems… the EQs on the right deck are wrong (high and mids) instead they control the filter, in the left deck on vinyl mode it starts scratching alone and not letting the song to play… i think its the preset I chose, it says LE SCS3 V1.00 … maybe I have to choose another? because the others are for dual or just the scs.3

    October 29, 2011 at 3:13 am #9150
    DjDre
    Member

    Hey Pancakes, I am also using the LE SCS3 V1.00 preset and everything is working fine for me. The only tip I can give is for your problem with the left deck — press vinyl mode again to be able to nudge as you would with a physical deck.

    November 2, 2011 at 1:13 am #9276
    Angelo Medina
    Participant

    DjDre, post: 9146 wrote: Hey Pancakes, I am also using the LE SCS3 V1.00 preset and everything is working fine for me. The only tip I can give is for your problem with the left deck — press vinyl mode again to be able to nudge as you would with a physical deck.

    yeah its now working properly! thanks for the help, just a question, what can you plug into the 2 usb ports it has in the front? I know you can connect the scs.d but it says I can connect other stuff…

    November 2, 2011 at 3:53 am #9282
    DjDre
    Member

    DR PANCAKES, post: 9272 wrote: yeah its now working properly! thanks for the help, just a question, what can you plug into the 2 usb ports it has in the front? I know you can connect the scs.d but it says I can connect other stuff…

    You can plug whatever you want (i.e. mouse, external hard drive, flash drive, etc.) in the front USB ports.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • The forum ‘DJing Software’ is closed to new topics and replies.